高清无码在线观看AV日韩欧美视频在线_国产91在线播放中文_中文字幕在线观看国产_国产综合视频在线观看一区_欧美一区二区三区成人看不卡_日韩一页亚洲国产精品区||www.cq8866.cn,少妇搡BBBBⅩXX搡BBB_FREE性少妇饥渴XXⅩXXHD_日韩精品一区国产偷窥在线_99精品国产综合久久久久五月天||www.qzfkyy.cn ,欧美重口另类在线播放二区_国产无遮挡吃胸膜奶免费看_老司机成人亚洲精品影院_久久人午夜亚洲精品无码区_久久五月精品中文字幕_国产一级做a爱片久久毛片a_六月丁香中文字幕||www.weixinsz.cn ,精品国产午夜理论片不卡|欧美日韩高清一区二区在线|久久99热这里只有精品23|国产精品一区二区久久精品无码||www.qssbzx.cn

With the continuous development of the plastic production industry, it needs to be applied to the feeding equipment that meets the requirements of its production. The centralized feeding system of the injection molding machine can ensure the operation efficiency of the plastic molding and the stable operation of the whole system, and also prevent the blocking phenomenon. Production site, the injection molding machine centralized feeding system will be raw materials and dry barrel completely separate management with the site, saving space. Now many manufacturers have the application of injection molding machine centralized feeding system, then we all know the injection molding machine centralized feeding system what are the advantages and disadvantages? The following together to understand.

Advantages:

1, injection molding machine central feeding system is the use of single machine design and construction of single-tube to ensure that the entire injection molding machine central feed system is stable, the pipeline in a closed vacuum, no blocking phenomenon.

2, injection molding machine central feeding system is used with the central drying system, you can use the dry air to feed raw materials to prevent the drying of good raw materials resurgence.

3, Under the effect of vacuum negative pressure, the original dust in the raw materials will be filtered through the dust filtration system. After each single suction, the air filter can be reversely cleaned to avoid interference caused by the filter clogging.

4. At the same time, when the operator removes dust, Hengrong Company newly developed a non-stop motor design, thus subverting the traditional shutdown to clear the dust barrier. This design not only avoids the frequent start-up of the fan, but also increases the production efficiency.

Disadvantages:

1, high equipment costs.
2, one-time investment in materials, difficult to replace the variety of materials.

The above is the introduction of the merits and demerits of the injection molding machine centralized feeding system. In addition, the centralized management of the raw materials for the injection molding machine centralized feeding system avoids the waste and pollution, and can well maintain the quality stability, increase the output value and maintain the quality system.